A hardworking washing machine may stop draining mid-cycle for a number of reasons, such as a kink in the drain hose, a clog of lint or fibers there, or a rogue article of clothing stuck in the drain pump. Fortunately, these kinds of washer mishaps are fairly simple to fix—in fact, the peskiest part of the process may be figuring out how to drain a washing machine of all the water in its drum so that you can avoid a mess during repairs.
Your first impulse may be to open the door and collect as much water as possible with a bucket, then sop up the rest with towels. But the smarter approach, whether you have a top-loading or front-loading machine, is to siphon the water through the drain hose directly into a bucket. Ahead, the know-how you need to tackle the task quickly and neatly, without dousing yourself or the floor in the process.
How to Drain a Top-Loading Washing Machine
STEP 1: Turn off the power.
Switch the power button on the machine off, if your model has one. Unplug the washing machine from the power source. Duct tape the power cord to the top of the machine to avoid splashing it with water or getting caught under the machine.
STEP 2: Locate the drain hose and water supply hoses.
Pull the washing machine away from the wall, if necessary, to access the drain hose. The drain hose is usually found on the back of the washer, along with two separate hoses for both cold and hot water supply. The drain hose carries wastewater out of the machine, while the hot and cold water supply hoses bring clean water in. The hot and cold water hoses are commonly color-coded red and blue, respectively, while the drain hose is typically gray. As a precaution, turn off the water supply by turning the red and blue knobs counterclockwise.
STEP 3: Drain the washing machine of water.
Depending on how your machine is configured, the drain hose may carry water into either a standpipe, a drainpipe in the wall, or a large nearby utility sink.
With a large bucket at the ready, disconnect the drain hose from the pipe by simply wigging it loose. Hold the hose up in the air until you’re ready to fill the bucket; once you lower the end of the hose below the water level of the water in the basin, gravity will cause the water to flow out.
If you need to pause and empty the bucket, place the disconnected end of the drain hose back into the drain pipe. Repeat this process until you completely drain the washing machine, holding the hose lower and lower to the ground as the water level in the basin decreases. You may need to utilize a shallower container like a 9-inch-by-13-inch baking dish in order to keep it as low to the ground as possible.
STEP 4: Remove a drain hose clog.
You may find when you lower the hose into the bucket that the water drains slowly or not at all. This likely indicates a blockage in the drain hose. Release it, using a plumbers snake. Push the tip of the coil in until you reach the blockage, turning manually with the handles on the opposite end until you get through the blockage.
Be prepared for water to flow out from the hose once you remove the clog.
STEP 5: Remove a drain pump clog.
If the clog doesn’t appear to be in the drain hose, it may be hiding in the drain pump. The drain pump may be located behind removable panels in either the front or back of the washing machine, even underneath the appliance, requiring you to tip the machine forward to access it (consult your owner’s manual for instructions). You’ll see a drain hose and inlet hose connected to it with spring clamps.
Once you’ve located the pump, remove the spring clamps by squeezing them with a pair of pliers. Clear any clogs that you find–which could range from a small article of clothing or a buildup of lint or pet hair—with a pair of needle-nosed pliers. Then reattach the hoses.